Пожалуйста, используйте этот идентификатор, чтобы цитировать или ссылаться на этот ресурс: http://earchive.tpu.ru/handle/11683/34986
Название: Forming a single layer of a composite powder based on the Ti-Nb system via selective laser melting (SLM)
Авторы: Saprykin, Aleksandr Aleksandrovich
Sharkeev, Yury Petrovich
Ibragimov, Egor Arturovich
Babakova, Elena Vladimirovna
Dudikhin, D. V.
Ключевые слова: слои; композиционные порошки; лазерное плавление; сплавы; имплантанты; титан-ниобий
Дата публикации: 2016
Издатель: IOP Publishing
Библиографическое описание: Forming a single layer of a composite powder based on the Ti-Nb system via selective laser melting (SLM) / A. A. Saprykin [et al.] // IOP Conference Series: Materials Science and Engineering. — 2016. — Vol. 140 : Interdisciplinary Problems in Additive Technologies : International Seminar, 16–17 December 2015, Tomsk, Russia : [proceedings]. — [012001, 9 p.].
Аннотация: Alloys based on the titanium-niobium system are widely used in implant production. It is conditional, first of all, on the low modulus of elasticity and bio-inert properties of an alloy. These alloys are especially important for tooth replacement and orthopedic surgery. At present alloys based on the titanium-niobium system are produced mainly using conventional metallurgical methods. The further subtractive manufacturing an end product results in a lot of wastes, increasing, therefore, its cost. The alternative of these processes is additive manufacturing. Selective laser melting is a technology, which makes it possible to synthesize products of metal powders and their blends. The point of this technology is laser melting a layer of a powdered material; then a sintered layer is coated with the next layer of powder etc. Complex products and working prototypes are made on the base of this technology. The authors of this paper address to the issue of applying selective laser melting in order to synthesize a binary alloy of a composite powder based on the titanium-niobium system. A set of 10x10 mm samples is made in various process conditions. The samples are made by an experimental selective laser synthesis machine "VARISKAF-100MB". The machine provides adjustment of the following process variables: laser emission power, scanning rate and pitch, temperature of powder pre-heating, thickness of the layer to be sprinkled, and diameter of laser spot focusing. All samples are made in the preliminary vacuumized shielding atmosphere of argon. The porosity and thickness of the sintered layer related to the laser emission power are shown at various scanning rates. It is revealed that scanning rate and laser emission power are adjustable process variables, having the greatest effect on forming the sintered layer.
URI: http://earchive.tpu.ru/handle/11683/34986
Располагается в коллекциях:Материалы конференций

Файлы этого ресурса:
Файл РазмерФормат 
dx.doi.org-10.1088-1757-899X-140-1-012001.pdf1,56 MBAdobe PDFПросмотреть/Открыть


Все ресурсы в архиве электронных ресурсов защищены авторским правом, все права сохранены.