Пожалуйста, используйте этот идентификатор, чтобы цитировать или ссылаться на этот ресурс: http://earchive.tpu.ru/handle/11683/36556
Название: Structural features of Ni-Cr-Si-B materials obtained by different technologies
Авторы: Kornienko, E. E.
Nikulina, A. A.
Belousova, N. S.
Lazurenko, D. V.
Ivashutenko, Alexander Sergeevich
Kuzmin, V. I.
Ключевые слова: структурные особенности; покрытия; плазменные напыления; спеченные материалы; плазменные покрытия; микротвердость
Дата публикации: 2016
Издатель: IOP Publishing
Библиографическое описание: Structural features of Ni-Cr-Si-B materials obtained by different technologies / E. E. Kornienko [et al.] // IOP Conference Series: Materials Science and Engineering. — 2016. — Vol. 156 : Materials and Technologies of New Generations in Modern Materials Science : International Conference and Youth Scientific School, 9–11 June 2016, Tomsk, Russia : [proceedings]. — [012020, 6 p.].
Аннотация: This study considers the structural features of Ni-Cr-Si-B (Ni - base; 15.1 % Cr; 2 % Si; 2 % B; 0.4 % C) materials obtained by different methods. The self-fluxing coatings were deposited by plasma spraying on the tubes from low carbon steel. Bulk cylinder specimens of 20 mm diameter and 15 mm height were obtained by spark plasma sintering (SPS). The structure and phase composition of these materials were investigated by optical microscopy (OM), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray diffractometry (XRD). The major phases of coatings and sintered materials are [gamma]-Ni, Ni[3]B, CrB and Cr[7]C[3]. We demonstrate that the particle unmelted in the process of plasma spraying or SPS consist of [gamma]-Ni-NEB eutectic and also CrB and Cr[7]C[3] inclusions. The prolonged exposure of powder to high temperatures as well as slow cooling rates by SPS provide for the growth of the structural components as compared to those of plasma coatings materials. High cooling rates at the plasma spraying by melted particles contribute to the formation of supersaturated solid solution of Cr, Si and Fe in [gamma]-Ni. The structure of the melted particles in sintering material has gradient composition: the core constituted of Ni grains of 10 μm with [gamma]-Ni-Ni[3]B eutectic on the edges. The results of the experiment demonstrate that the sintering material has a smaller microhardness in comparison with plasma coatings (650 and 850 MPa, respectively), but at the same time the material has higher density (porosity less than 1 %) than plasma coatings (porosity about 2.. .3 %).
URI: http://earchive.tpu.ru/handle/11683/36556
Располагается в коллекциях:Материалы конференций

Файлы этого ресурса:
Файл Описание РазмерФормат 
dx.doi.org-10.1088-1757-899X-156-1-012020.pdf1,3 MBAdobe PDFПросмотреть/Открыть


Все ресурсы в архиве электронных ресурсов защищены авторским правом, все права сохранены.