Пожалуйста, используйте этот идентификатор, чтобы цитировать или ссылаться на этот ресурс:
http://earchive.tpu.ru/handle/11683/33902
Название: | Distribution of contact loads over the flank-land of the cutter with a rounded cutting edge |
Авторы: | Kozlov, Victor Nikolayevich Gerasimov, A. Kim, Aleksey Bogovich |
Ключевые слова: | контактные нагрузки; фрезы; режущие кромки; износ; титановые сплавы; обработка; резаки; режущие инструменты |
Дата публикации: | 2016 |
Издатель: | IOP Publishing |
Библиографическое описание: | Kozlov V. N. Distribution of contact loads over the flank-land of the cutter with a rounded cutting edge / V. N. Kozlov, A. Gerasimov, A. B. Kim // IOP Conference Series: Materials Science and Engineering. — 2016. — Vol. 124 : Mechanical Engineering, Automation and Control Systems (MEACS2015) : International Conference, 1–4 December 2015, Tomsk, Russia : [proceedings]. — [012173, 7 p.]. |
Аннотация: | In this paper, contact conditions between a tool and a workpiece material for wear-simulating turning by a cutter with a sharp-cornered edge and with a rounded cutting edge are analysed. The results of the experimental study of specific contact load distribution over the artificial flank wear-land of the cutter in free orthogonal turning of the disk from titanium alloy (Ti[6]Al[2]Mo[2]Cr), ductile (63Cu) and brittle (57Cu1Al[3]Mn) brasses are described. Investigations were carried out by the method of 'split cutter' and by the method of the artificial flank-land of variable width. The experiments with a variable feed rate and a cutting speed show that in titanium alloy machining with a sharp-cornered cutting edge the highest normal contact load ([sigma][h max]=3400...2200 MPa) is observed immediately at the cutting edge, and the curve has a horizontal region with the length of 0.2... 0.6 mm. At a distance from the cutting edge, the value of specific normal contact load is dramatically reduced to 1100...500 MPa. The character of normal contact load for a rounded cutting edge is different -it is uniform, and its value is approximately 2 times smaller compared to machining with a sharp-cornered cutting edge. In author's opinion it is connected with generation of a seizure zone in a chip formation region and explains the capacity of highly worn-out cutting tools for titanium alloys machining. The paper analyses the distribution of tangential contact loads over the flank land, which pattern differs considerably for machining with a sharp-cornered edge and with a rounded cutting edge |
URI: | http://earchive.tpu.ru/handle/11683/33902 |
Располагается в коллекциях: | Материалы конференций |
Файлы этого ресурса:
Файл | Описание | Размер | Формат | |
---|---|---|---|---|
dx.doi.org-10.1088-1757-899X-124-1-012173.pdf | 973,69 kB | Adobe PDF | Просмотреть/Открыть |
Все ресурсы в архиве электронных ресурсов защищены авторским правом, все права сохранены.