Cutting Edge Geometry Effect on Plastic Deformation of Titanium Alloy

Abstract

The paper presents experimental studies of ОТ4 titanium alloy machining with cutting edges of various geometry parameters. Experiments were performed at a low speed by the scheme of free cutting. Intensity of plastic shear strain was set for defining of cutting edge geometry effect on machining. Images of chip formed are shown. Estimation of strain magnitude was accomplished with digital image correlation method. Effect of rake angle and cutting edge angle has been studied. Depth of deformed layer and the area of the plastic strain is determine. Results showed that increasing the angle of the cutting edge inclination results in a change the mechanism of chip formation.